Memory Test: Difference between revisions
Update to one memtest section for all x86 NAS models |
mNo edit summary |
||
| Line 36: | Line 36: | ||
4. Power on the NAS and press the <DEL> key to enter BIOS setup. | 4. Power on the NAS and press the <DEL> key to enter BIOS setup. | ||
5. Press the right arrow key to navigate to the Boot settings screen and configurechange the boot order | 5. Press the right arrow key to navigate to the Boot settings screen and configurechange the boot order. | ||
[[File:bios boot 01.jpg|RTENOTITLE]] | [[File:bios boot 01.jpg|RTENOTITLE]] | ||
| Line 50: | Line 50: | ||
7. Press the right arrow key to navigate to Save and Exit to save configuration and exit | 7. Press the right arrow key to navigate to Save and Exit to save configuration and exit | ||
[[File:boot 04.jpg|RTENOTITLE]] | [[File:bios boot 04.jpg|RTENOTITLE]] | ||
8. The memory test will begin automatically | 8. The memory test will begin automatically | ||
Revision as of 16:15, 7 December 2017
This page will detail how to run a full test of the NAS memory using the Memtest86+ utility.
This procedure only applies to NAS models with Intel and AMD CPU.
Memory Test SOP for x86-based NAS
Applied QNAP NAS models
NAS models with Intel and AMD CPU
Instructions for Performing the Memory Test
A. How to create a Memtest USB boot disk.
- Go to http://www.memtest.org/#downiso and download the latest "Auto-installer for USB Key" file.
- Extract the zip file to the folder you downloaded it to.
- Plug a USB flash drive to your PC and run the Memtest Auto-Installer file extracted from the step above to create a bootable USB
B. How to use the Memtest USB boot disk to test the NAS memory
1. Power off the NAS.
2. Remove all the hard disks.
3. Connect the NAS with a VGA/HDMI monitor, USB keyboard, and the bootable USB disk.
4. Power on the NAS and press the <DEL> key to enter BIOS setup.
5. Press the right arrow key to navigate to the Boot settings screen and configurechange the boot order.
6. Reconfigure the first boot device to your USB flash drive. Select "Patriot Memory PMAP" or similar name showing your USB disk
[NOTE]: If there are two USB devices, don't select “USB DISK MODULE PMAP”.
7. Press the right arrow key to navigate to Save and Exit to save configuration and exit
8. The memory test will begin automatically
